Description
The Craft Annular Hole Cutter Hss 26 X 30MM Broach Slugger Bit is a tool that is used to make holes in tube and pipe. The annular cutter is hollow on the inside, which eliminates the dead zone resistance that is encountered when drilling with a twist drill. This allows for faster cutting and less chatter. The slug also offers a higher scrap value than loose chips and shavings.
Annular Cutters 30mm
Annular Cutter: Ø 26 mm
One way to avoid dimpling and deburring while making holes in tube and pipe is to use annular cutters. Because annular cutters are hollow on the inside, there is no dead-zone resistance to overcome. Using a twist drill to make holes in pipe or tubing can prompt concerns about the hole roundness, location accuracy, hole finish, chip extraction, burrs, and drilling duration. The focal point of these concerns is the twist drill's most noticeable feature; its point. This is not really a point at all, but the tangent line where two cutting angles intersect at the web of the drill, or the so-called 'dead zone.' This dead zone causes the surface speed of the cutting edges to drop to zero. The lower surface speed reduces cutting efficiency and requires increased thrust, or feed pressure, for the cutting edges to push through the material. Compared to traditional tooling (twist drills, etc.) annular cutters can multiply your cutting speed by up to 3 times while getting a longer tool life, a more accurate hole, a better finish, with no burrs. The cutting edges distribute the cutting load evenly, thus making it faster cutting. Annular cutters convert a smaller area to chips, requiring less horsepower and thrust. This feature provides longer tool life and less chatter. The slug also offers a higher scrap value than loose chips and shavings.
Definition - Annular 'Ring-shaped' or 'forming a ring'. From the latin word annulus
Related Products
