Description
This lithium polymer stick-type battery is designed specifically to power airsoft AEGs. As a stick-type battery, it is designed to fit comfortably inside any suitable AEG without sacrificing power or efficiency. This 3-cell battery provides 11.1v of power and comes with a T-Plug battery connector which is ready to connect with any accommodating circuit.
A key benefit of Li-Po batteries is that they can provide better power efficiency in more compact packages. Therefore, Li-Po batteries such as this are an excellent power source for small carbines, PDW's, SMG's, etc.
Unlike other batteries, Li-Po provides a consistent rate of fire across its lifespan and it is not necessary to discharge Li-Po batteries before recharging them, allowing the battery to be charged in between games.
Specification:
Capacity: 2200mAh
Voltage: 11.1V
Discharge Rate: 30C
Connector: T plug
Dimensions: 105*34*20mm
Net Weight: 161g
Battery Cell Type: Lithium Polymer
To prolong the life of a Li-Po battery:
Never completely discharge the battery.
Stop using the battery the moment you hear the rate of fire begin to drop.
Charge the battery before storage.
IMPORTANT: You must use a Li-Po charger, no exceptions.
WARNINGS
Only use approved LiPo chargers and never use a NiMH or NiCd charger to charge LiPo
Do not pierce the battery
Do not disassemble the battery
Do not short-circuit the battery terminals
Do not connect the battery directly to an electrical outlet
Do not strike or throw the battery against hard surfaces
Do not immerse the battery in water or seawater
Always disconnect the battery immediately after use, charging or discharging and keep the battery in a cool, dry environment during stand-by periods
Do not use, throw or leave the battery near heat source such as fire or heater
The battery should not be charged with more than a current of 1C (e.g. a 1200 mAh battery should be charged with 1.2 A (1200 mA)). Charging with higher currents can potentially damage battery cells or even lead to overheating or other serious failures
Stop charging immediately if temperature exceeds 45C
Stop using battery if temperature exceeds 60C - Never leave LiPo batteries charging unattended
Always monitor the charging process of your LiPo batteries so that you can react immediately to any potential problems
If your LiPo batteries start to balloon or swell up, discontinue charging/discharging/usage
Before and after use of your LiPo batteries, inspect them to ensure that there is no physical damage or swelling as those are signs of imminent failure
Related Products
