Description
Compact size make this Li-Po battery pack perfect for Airsoft guns that uses mini type batteries as well as custom modified Airsoft guns and for AN/ Peq-5 boxes. It will outperform and outlast traditional 7 or 8 cell NiCad or NiMH batteries.
Battery specs:
Configuration: Single pack.
Voltage: 7.4V.
Capacity : 1000mAh.
Comes with align balance connector.
Dimensions: 58x29x17mm (2,4x1,2x0,7 in.)
Size compatible with mini-type batteries.
This pack is ideal for M90 to M120 upgrades.
Replaces an 8.4V to 9.6V NiMH pack.
Ultra-advanced Li-Po battery technology.
To prolong the life of a Li-Po battery:
Never completely discharge the battery.
Stop using the battery the moment you hear the Rate of Fire goes down.
IMPORTANT: you must use a Li-Po charger, no exceptions.
The biggest reasons to use a Li-Po are its smaller size and better power efficiency. Most Li-Po batteries are about the same size as a mini-type battery and are equal in power to a large type NiMH battery. No need for battery slings or big batteries strapped on to guns. Li-Po is a power source for small carbines, PDW's, SMG's, etc. that doesn't require you to spoil the look of the gun, or run the risk of running out of power in the middle of a battle.
Unlike traditional batteries, Li-Po gives a stable Rate of Fire, through-out its use. Also, it is not necessary to discharge Li-Po batteries before charging them, allowing the battery to be charged in-between games.
WARNINGS
Only use approved LiPo chargers and never use a NiMH or NiCd charger to charge LiPo
Do not pierce the battery
Do not disassemble the battery
Do not short-circuit the battery terminals
Do not connect the battery directly to an electrical outlet
Do not strike or throw the battery against hard surfaces
Do not immerse the battery in water or seawater
Always disconnect the battery immediately after use, charging or discharging and keep the battery in a cool, dry environment during stand-by periods
Do not use, throw or leave the battery near heat source such as fire or heater
Do not dispose of the battery in fire or heat
The battery should not be charged with more than a current of 1C (e.g. a 1200 mAh battery should be charged with 1.2 A (1200 mA)). Charging with higher currents can potentially damage battery cells or even lead to overheating or other serious failures
Stop charging immediately if temperature exceeds 45C
Stop using battery if temperature exceeds 60C - Never leave LiPo batteries charging unattended
Always monitor the charging process of your LiPo batteries so that you can react immediately to any potential problems
If your LiPo batteries start to balloon or swell up, discontinue charging/discharging/usage
Before and after use of your LiPo batteries, inspect them to ensure that there is no physical damage or swelling as those are signs of imminent failure
Related Products
